Новый термопластавтомат Engel e-victory 50/50

ENGEL – Injection Moulding Machine Technical Data
Serial number: 232665
Model: E‑VICTORY
Plasticising Unit 1
Screw diameter: 18 mm
Listed diameter options: 15 / 18 / 20 mm
18 mm is installed
Screw stroke: 80 mm
Maximum injection volume: 20 cm³
Screw speed: 450 rpm
Screw torque: 75 Nm
Plasticising rate
3-zone screw: 4.2 g/s
Injection Unit 1
Version: Standard
Injection rate: 83.97 cm³/s
Specific injection pressure
regenerative mode: 2,400 bar
Nozzle 1
Nozzle stroke: 210 mm
Nozzle contact force: 40.6 kN
Material Cylinder 1
Screw L/D ratio: 24
Heating zones
including nozzle: 4
Heating power: 5.1 kW
Note: maximum available equipment
Clamping Unit
Clamping force: 500 kN (approximately 50 tonnes)
Opening stroke + cylinder tolerance: 408 mm
Maximum distance between platens: 600 mm
Minimum mould height: 200 mm
Platen dimensions
horizontal × vertical: 500 × 450 mm
Drop-out chute width: 400 mm
Maximum mould weight on moving platen: 300 kg
Maximum mould weight on stationary platen: 300 kg
Maximum total mould weight: 600 kg
Dry-cycle stroke according to Euromap 6: 150 mm
Dry-cycle time according to Euromap 6: 1.60 s
Mould weight notes
Ejector 1
Ejector stroke: 100 mm
Ejector force: 39.8 kN
Drive Unit
Oil reservoir capacity – injection unit
main tank: 135 l
Oil reservoir capacity – clamping unit
auxiliary tank: 0 l
Machine Basics
Total weight without oil: 4.0 tonnes
Total connected power: 65.0 kW
Transcription note: the small footnotes below the plasticising section specify reference materials and test conditions. They are not fully legible in this photo